Using this on our 10 year old maytag neptune front loading wash machine.
Maytag neptune washer hot water valve.
As a result water can leak into the washer and cause it to overflow.
Thank you and have a great day.
Northridge ca 91324 1 877 477 7278 tennessee 240 edwards st.
If power is removed and the solenoid operated input water valve is questionable then it may leak.
Our water pressure in our home is about 94 psi.
Genuine maytag neptune washer water inlet valve 22002795 wp22002795.
Check the water pressure to determine if it is sufficient.
Watch this how to video with simple step by step instructions for a succe.
How do i replace the water inlet valve on a maytag neptune washer.
A problem with the valve can cause the washer not to fill properly or not fill at all.
Next remove the four wires and loosen up the clamp.
Hi george thank you for your question.
To gain access to the water valve locate the back of the washer and remove the hot and cold hoses as well as the whole assembly.
Free shipping on many items.
Cleveland tn 37311 1 877 477 7278.
If cold water does not flow into washer or the washing machine will not fill with hot water replacing the valve can be the solution.
I turned the water off at the wall.
For most washers water enters the unit from two valves on the rear of the appliance we have a few models that only have one inlet valve.
You will need to check the hot water valve the door lock latch the cold water valve the hose clamp and the drain pump.
New ap3267279 washer water inlet valve fits frigidaire.
California 19410 business ctr dr.
The power went off the other day and i heard water dripping into the washer.
Need help replacing the inlet water valve part wp21001932 in your maytag washer.
If the washer will not fill with water there are some parts that you will need to check to see which one is causing the issue.
I can t figure out how to remove it so that i buy the correct replacement part.
Whirlpool 22003834 water valve thermistor.
Report this by hickslees hickslees.
The water won t stop running into the machine after the deep freeze a couple of weeks ago.
We hope this helps.
There is little that you can do to repair the valve itself but you can clean the two inlet ports to restore full water flow.
If the water inlet valve does not get enough pressure the valve may not close fully after the power is shut off.
One valve regulates the hot water and the other valve regulates the cold water.