The specific method varies by make and model.
Maytag washer fabric softener dispenser problem.
John home appliance technician.
With drawer pulled out after initial fill and wash water enters back of dispenser in a trickle for rinsing never flowing through top right roof section of cavity through holes to drop into fabric softener well.
He3t fabric softener dispenser not working.
On a top loading washing machine the fabric softener dispenser may be located in a special dispenser cup at the center of the agitator.
This is relatively rare because the fabric softener water valve only gets used for a few minutes each wash but it can go faulty.
The water lines could be kinked or clogged with residue.
Detergent bleach and fabric softener are dispensed at the proper time in the laundry cycle by a burst of water that flushes out the dispenser cup.
Remove the fabric softener dispenser from the washing machine by pressing a release lever squeezing side tabs or simply lifting it out.
Fabric conditioner if the washing machine is going through the wash program properly but the fabric softener isn t being taken out it s possible the water valve which flushes it away into the machine has failed.
Check that the additives detergent fabric softener liquid chlorine bleach and oxi are in the appropriately marked compartments.
If the fabric softener is not dispensed and you notice the dispenser still full at the end of the wash cycle you may need to replace the dispenser.
This is the tall cylinder that sticks up from the bottom of the washer tub.
This is an oem part sourced directly from the manufacturer and is sold individually.
Remove the dispenser by pressing the release lever and rinse leftover detergent or additives that could clog the flow of water through the dispenser.
To use fabric softener in your top loading machine fill the dispenser with the amount of product recommended by the manufacturer.
You should mis the water and softener together before you fill the dispenser the fabric softer will clod it up if its not diluted it come off by pulling and twisting.
If dispensers will not work correctly is often a problem with the water flow into the unit.