I replaced the lamp and now the green light won t stop blinking i even pushed the factory reset and it is still blinking.
Mitsubishi wd 73640 red light.
I have a mitsubishi wd 52528 rear projection tv it wont turn on any more the green power light blinks for about 30sec and shuts down and than turns back on and the green light blinks for 30sec over a read more.
I replaced the main board as well as the power supply board.
If after you have attempted to recycle the ac power and the hdtv has not fully powered on please contact mitsubishi consumer relations.
I have the same problem with my television.
Unplug the ac cord from the wall power outlet and waiting 60 seconds before reapplying ac to the hdtv.
Mike i read your response to the mitsubishi wd 73640 flashing green light.
Mike i read your response to the mitsubishi wd 73640 flashing green light.
A failing lamp can fire up for several seconds or minutes and then cause the set to shut down due to the lamp getting hot.
The red blinking light directly indicates that the lamp has failed or is failing and needs to be replaced.
If i disconnect the ballast the tv comes on with sound then after a few minutes the red.
The only light that.
Led blinking red typically indicates that there is a fault with the hdtv.
Follow the support for questions.
Thank you for your professional.
Then press the power button on the tv and if the condition of the tv is the same as before please call mitsubishi consumer relations department for help troubleshooting 1 800 332 2119.
Page 2 tv and will not be covered by the warranty.
I have a mitsubishi 73 wd 73734.
I have a mitsubishi wd 73640 dlp hdtv when you turn it on the light is solid green after about 5 minutes the light turns to solid red sometimes you can hear sound but rarely screen is black i also do here to fans running when powered on but no picture before this happened there was no problem with the tv no white dots or no snowy picture the lamps have never been replaced.
Hi all i had the blinking green light and it seems to have been the fmt board.
Unplug the ac cord from the wall power outlet and wait for 60 seconds before plugging it back in.