Using this wiring set up you can override the sensor to be off all the time on all the time or controlled by the motion sensor.
Motion sensor light switch manual override.
If both switches are now connected in parallel the closed switch will always override the open switch.
This is a wiring diagram for a motion sensor controlled shop light led using a single pole double throw 3 position switch.
Your outdoor sensor lights are not working or they seem less sensitive than usual.
The only thing this that you d need to turn the spst switch off and hit the manual override button on the motion sensor to turn the lights off immediately if you d previously had them held on.
The sensor will learn your preferred light level over time.
These lights are designed to go off after movement has ceased generally within 30 to 60 seconds.
Posted by supercres at 6 47 pm on march 24 2019.
Choose a time at twilight or when the outdoor light comes on with motion.
Your motion sensor light stays on.
On when there is enough natural light or if the switch does not turn on when there is not enough natural light press the on off button within 5 seconds of entering the room.
If your motion sensor light won t go off or stays on for long periods of time it may require a reset.
If you use your outside lights all the time you would like to have the light stay on when you re outside entertaining or you ve heard noises and want the light to remain on for the rest of night there is a special switch you can change to which will make overriding the sensor really simple if the method mentioned above is not suitable.
The output of a motion detector is also a simple switch with the same functionality.
Wait for it to time out and shut off again.
Feature that can be enabled or disabled to accommodate different lighting.
In principle a simple light switch has two contacts which interrupt the current flow in the off state and pass it through in the on state.
A switch on the fixture should read on time usually found directly under the motion sensor.
This is a pretty common use case now many people have a motion sensor set to automatically turn the lights off after inactivity but they want the manual wall switch to override that rule.
Wave your hand in front of the sensor to trip the light to come on.
I think the most common way to do this is with webcore which is a very sophisticated rules engine developed by the community.